Sursa modulara 1800 wati AC-DC, ARTESYN, gen. 2, model uMP16S-SKW-S2I-S2J-S2L-00. Sursa este noua.

Input range 85 to 264 VAC 120 to 350 VDC (limited to 300 VDC in medical applications)
Frequency 47 to 440 Hz
Inrush current 40 A peak max. (soft start)
Efficiency Up to 91.5% full case load
Power factor 0.99 typ. meets EN61000-3-2 (n/a 440 Hz)
Standby power uMP10/16 13 W
uMP04/09 6 W
Turn-on time AC on 2 sec for μMP16/10 and 1.5 sec for μMP04/09, inhibit/enable 250 ms typical
EMI: CISPR 22/EN55022 Level “B” (Both Conducted and Radiated)
Leakage current 200 uA using center-tapped xfmr measurement method.
(400 uA 240 VAC input)
Holdover storage 16.7 ms minimum (independent of input Vac, 0 °C to 50 °C)
At 1200 W for μMP16
AC OK Signal goes low indicating loss of AC input.
Hold up = Full cycle ride thru (50 Hz); Open collector
Harmonic current emission Meets EN61000-3-2
Isolation Meets EN62368 and EN60601
Global inhibit/enable TTL, Logic “1” and Logic “0”; fan off when unit is inhibited
Input fuse (internal) μMP16/10: 16 A, 500 VAC 400 VDC, μMP04/09: 10 A / 250 V. (both lines fused)

Output
Factory set point accuracy ± 1%
Margining / V-Program ± 3 - 7% nominal analog (single output module only). Contact factory for simple V-program
modification (i.e. 0-5 V input = 0-100% output voltage).
Overall regulation 0.4% or 30 mV which ever is greater
Ripple RMS: 0.1% or 10 mV, whichever is greater
Pk-Pk: 1.0% or 50 mV, whichever is greater. Bandwidth limited to 20 MHz
Dynamic response ± 5% or 250 mV, with 50% step load, Min 20% load condition
Recovery time To within 1% in 300 μsec
Reverse voltage protection 100% of rated output current
Thermal protection (OTP) All outputs disabled when internal temp exceeds safe operating range
Remote sense Up to 0.5 V total drop (not available on triple output module)
Single wire parallel Current share to within 5% of total rated current from 20% to 100% rated load
DC OK ± 5% of nominal Open collector
Minimum load Not required
Housekeeping standby 5 VDC 2.0 A max whenever AC input is applied. 1.0 A (2.0 A for μMP04) max convection cooled
(when output is inhibited off)
Module inhibit Logic - output on with low or open. Different logic options available
Output/Output isolation > 1 Megohm, 500 VDC

Operating temperature -40°C to 70°C ambient. Derate each output 2.5% per degree from 50°C to 70°C. Cold start soak
-20 °C, allow 10 min warm-up before all outputs are within specification. Reverse air to 40 °C Max due
to fan derating.
Storage temperature -40°C to +85°C
Electromagnetic susceptibility Designed to meet EN61000-4:-3,-5,-6,-11 Class 3 Performance Criteria A
Humidity Operating; non-condensing 10% to 95% RH
Vibration MIL-STD-810E
MTBF demonstrated > 350,000 hours at full load, one μMP04 case + two modules, Telcordia SR-332 calculated MTBF
Altitude Up to 10 K feet; derate linear to 50% from 10 K to 30 K feet
ENVIRONMENTAL SPECIFICATIONS
Vout Full load (A) OVP trip max (V) OCP trip typ (Iout%) SCP trip max (Iout%) Overshoot (max mV) Peak Deviation (max mV)
3 V 3 Module
0.9 40 2.00 V 130% 160% 150 ± 250
3.3 40 5.96 V 130% 160% 250 ± 250
3.6 40 6.31 V 130% 160% 250 ± 250
5 V Module
3.2 36 5.76 V 130% 160% 250 ± 250
5 36 9.0 V 130% 160% 250 ± 250
6 30 10.80 V 130% 160% 300 ± 300
12 V Module
6 25 10.80 V 130% 160% 300 ± 300
12 20 15.60 V 130% 160% 600 ± 600
15 16 19.50 V 130% 160% 750 ± 750
24 V Module
12 13 15.60 V 130% 160% 600 ± 600
24 10 31.20 V 130% 160% 120 ± 1200
30 8 39.00 V 130% 160% 1500 ± 1500
48 V Module
28 7 36.40 V 130% 200% 1400 ± 1400
48 5 62.40 V 130% 160% 2400 ± 2400
60 4 78.00 V 130% 200% 3000 ± 3000
Case
Max Output
Dimensions Connections Max Continous
Current 85-180 VAC 180-263 VAC
μMP04 - 4 Slot 400 W 600 W
256.9 x 88.9 x 40.0
(10.11” x 3.5” x 1.57”)
IEC, Terminal-Block,
Barrier-Strip 9.91
μMP09 - 4 Slot 550 W 1100 W
256.9 x 88.9 x 40.0
(10.11” x 3.5” x 1.57”)
IEC, Terminal-Block,
Barrier-Strip 9.91
μMP10 - 6 Slot 1000 W 1200 W
256.9 x 127 x 40.0
(10.11” x 5.0” x 1.57”)
IEC, Terminal-Block,
Barrier-Strip 13.87
μMP16 - 6 Slot 1000 W 1800 W
256.9 x 127 x 40.0
(10.11” x 5.0” x 1.57”)
IEC, Terminal-Block,
Barrier-Strip 1